typical intermodulation performance at 25 oc second order harmonic intercept point ....... +51 dbm (typ.) second order two tone intercept point ........ +45 dbm (typ.) third order two tone intercept point ............ +35 dbm (typ.) legend +25 oc +85 oc - - - - - - -55 oc power vdc +7 +7 ma 80 85 max. rf amplifier model TM4003PM high gain: 20 db typical characteristic typical min/max ta= 25 oc ta = -55 oc to +85 oc frequency 10 - 500 mhz 10 - 500 mhz note: care should always be taken to effectively ground the case of each unit. noise figure (db) 4.0 5.0 max. vswr in 1.4:1 1.75:1 max. out 1.3:1 1.75:1 max. reverse isolation (db) -23 -22 max. power @ 1 db comp. (dbm) +19.5 +18.5 min. gain (db) +20 +19 min. specifications typical performance data absolute maximum (no damage) ratings ambient operating temperature ................ -55oc to +100 oc storage temperature ................................. -62oc to +125 oc case temperature .................................................. +125 oc dc voltage ........................................................... +8 volts continuous rf input power .................................. +10 dbm short term rf input power .... 200 milliwatts (1 minute max.) maximum peak power .................... 0.5 watt (3 sec max.) available as: TM4003PM, 4 pin to-8 (t4) tn4003pm, 4 pin surface mount (sm3) bx4003pm, connectorized housing (h1) rev. 8/16/10 residual phase noise test conditions: ? carrier frequency: 320 mhz ? power output +19 dbm ? temperature: 25 o c ? ? ? ? ? agilent es5500 system frequency typical 100 hz 1 khz 162 160 10 khz 170 165 100 khz 170 165 1 mhz 170 165 guarantee (min.) 152 150 output power: +19.5 dbm typical low +7 volt supply operating temp. -55 oc to +85 oc features spectrum microwave 2144 franklin drive n.e. palm bay, florida 32905 ph (888) 553-7531 fax (888) 553-7532 spectrum microwave 2707 black lake place philadelphia, pennsylvania 19154 ph (215) 464-4000 fax (215) 464-4001 www.spectrummicrowave.com guaranteed @ 25 oc (320 mhz) phase noise performance (dbc/hz) * *note: phase noise performance typically tested at midband. bandedge performance may vary.
|
